TMPro module 108 - Yamaha bikes immobox Moric type 2

TMPro module 108 – Yamaha bikes immobox Moric type 2

500,00 € excl. VAT

Module for creating immobilizer transponders for Moric immo boxes used in Yamaha vehicles. Easy and efficient solution.

Important Information:

We sell new and unused goods (unless stated otherwise)!
Before each shipment, the goods are inspected and/or tested for functionality, if possible.
Delivery times may be affected by the courier service.
We also perform repairs on control units and can assist you.

This is new variant of Yamaha immobox, where there is no serial eeprom S29190.
On place, where you must find serial eeprom S29190, you find 16-pin chip TMS3705.
Keys ARE NOT in this chip TMS3705!

Memory device is MORIC MCU 30 pins SSOP package.
MORIC MCU in this immobox IS NOT POSSIBLE TO READ!
Programming of MORIC MCU is thru TMPro, view connection diagrams and instructions.
Use TMPro chip or Yamaha key or Texas Crypto – Silca 4D-60 – JMA TP06/TP19 transponder.

Written transponder is ready programmed to start bike.

Also you can set immobox to virgin state.

IMPORTANT NOTE: You can program ONE MASTER key and ONE SLAVE key. If you want more slave keys, program a slave key and clone it with software 65.
IMPORTANT NOTE: If you want to program MASTER key, you also MUST RESET engine ECU (set engine ECU to VIRGIN state), because programming of MASTER key will DELETE synchronisation MORIC immobox – engine ECU. Procedure how to reset Yamaha engine ECU is described HERE.

Vehicles equipped with this unit:
Yamaha: All models after year 2010,including but not limiting to R1, T-MAX, R6, BT1100, FJR, FZR, FZ1, FZ6, FZS, XT, XJR, XTR, XTX, XVX, MT etc…

Important Information: Before purchasing the module, make sure you also have the TMPro2 Transponder Key Programmer. This module cannot function independently!